How to do a basic maintenance to a notebook. In the following steps we will explain how to perform a basic maintenance to a notebook without disarming all the equipment.
STEP 1:
We have our cleaning kit, foam, clean contacts and compressed air, brushes, cleaning cloths, antistatic wristband, and a container to place the screws to extract.
STEP 2:
Before cleaning the equipment we check that it works and is working well, after checking the equipment we turn it off and proceed to give it its maintenance.
STEP 3:
We extract the battery as the first point before extracting another component, such as a mini notebook carefully remove the cover below without breaking any staple.
STEP 4:
We extract the shielding sheet that covers the RAM and then we remove the safe to extract the RAM.
STEP 5:
We extract the screws that are holding the HDD and then we extract it.
STEP 6:
Remove the Wi-Fi card, before disconnecting, note how the colors of the antenna cable are connected and remove the screws to remove the card.
STEP 7:
To remove the keyboard, remove the screws from the bottom and then at the top, carefully remove the clips and disconnect the flex.
STEP 8:
Once the pieces are removed, we proceed to clean them with the brush and apply clean contacts.
STEP 9:
Once the parts of the equipment have been removed, we clean it with a brush and we apply air to all surfaces of the fan, RAM, HDD, Wi-Fi card and USB ports, and we apply clean contacts to it. And foam to the plastic surface,
STEP 10:
The screen is cleaned with an LCD screen cloth that does not scratch the screen and does not stain it. Liquid LCD is applied. After this wait a minimum of 30 minutes to dry the parts internally and proceed to perform the assembly of it.
STEP 11:
To carry out the assembly of the equipment, we will do it based on the steps described above.
STEP 12:
We turn on the equipment to see that its operation is correct.
STEP 1:
We have our cleaning kit, foam, clean contacts and compressed air, brushes, cleaning cloths, antistatic wristband, and a container to place the screws to extract.
STEP 2:
Before cleaning the equipment we check that it works and is working well, after checking the equipment we turn it off and proceed to give it its maintenance.
STEP 3:
We extract the battery as the first point before extracting another component, such as a mini notebook carefully remove the cover below without breaking any staple.
STEP 4:
We extract the shielding sheet that covers the RAM and then we remove the safe to extract the RAM.
STEP 5:
We extract the screws that are holding the HDD and then we extract it.
STEP 6:
Remove the Wi-Fi card, before disconnecting, note how the colors of the antenna cable are connected and remove the screws to remove the card.
STEP 7:
To remove the keyboard, remove the screws from the bottom and then at the top, carefully remove the clips and disconnect the flex.
STEP 8:
Once the pieces are removed, we proceed to clean them with the brush and apply clean contacts.
STEP 9:
Once the parts of the equipment have been removed, we clean it with a brush and we apply air to all surfaces of the fan, RAM, HDD, Wi-Fi card and USB ports, and we apply clean contacts to it. And foam to the plastic surface,
STEP 10:
The screen is cleaned with an LCD screen cloth that does not scratch the screen and does not stain it. Liquid LCD is applied. After this wait a minimum of 30 minutes to dry the parts internally and proceed to perform the assembly of it.
STEP 11:
To carry out the assembly of the equipment, we will do it based on the steps described above.
STEP 12:
We turn on the equipment to see that its operation is correct.
